Zaptel configuration problem.

Discussion in 'General' started by hetii, Jun 12, 2007.

  1. hetii

    Joined:
    Jun 7, 2007
    Messages:
    32
    Likes Received:
    0
    Hello

    I install sangoma card A101x on elastix platform but i have problem to proper configuration it into zapata* files (on first time i use wancfg_zaptel tools):

    in flash operator panel at section Trunks i see 19 zap position, but i don`t now why is 19 and from system get it (ofc i check zapata.conf.template and zapata_additional.conf).

    here is my current configuration(on all lines where is ;; i comment its from original to my setting's):

    zapata_additional.conf:
    ; do not edit this file, this is an auto-generated file by freepbx
    ; all modifications must be done from the web gui

    zapata-auto.conf:
    callerid=asreceived
    ;I put this manualy:
    ;Sangoma A101 port 1 [slot:4 bus:2 span: 1]
    context=from-zaptel
    group=0
    signalling=pri_cpe
    channel => 1-15,17-31

    zapata.conf:

    [trunkgroups]

    [channels]
    ;;context=default
    context=from-zaptel
    usecallerid=yes
    hidecallerid=no
    callwaiting=yes
    usecallingpres=yes
    callwaitingcallerid=yes
    threewaycalling=yes
    transfer=yes
    canpark=yes
    cancallforward=yes
    callreturn=yes
    echocancel=yes
    echocancelwhenbridged=yes
    rxgain=0.0
    txgain=0.0
    ;;group=1
    group=0
    callgroup=1
    pickupgroup=1

    immediate=no

    ;Sangoma A101 port 1 [slot:4 bus:2 span: 1]
    switchtype=national
    ;I comment this manualy:
    ;;context=from-pstn
    ;;group=0
    ;;signalling=pri_cpe
    ;;channel => 1-15,17-31
    ;--------------------------------

    ;I put this manualy:
    ;Include genzaptelconf configs
    #include zapata-auto.conf
    group=1
    ;Include AMP configs
    #include zapata_additional.conf

    zapata.conf.template:
    [channels]
    language=en

    ; include zap extensions defined in AMP
    #include zapata_additional.conf


    Best Regards
     

Share This Page