Zap Extension Wait 4 Second Before Dial The Trunk

Discussion in 'General' started by ismed, Dec 9, 2009.

  1. ismed

    Joined:
    Oct 1, 2009
    Messages:
    120
    Likes Received:
    0
    Dear Experts,
    I am using elastix 1.6 (32) on Intel Mobo with E7500 Procie, and with Digium TDM410 with 2xFXS port and 2xFXO port. I noticed that when I dial a pstn number using a FXS Extension elastix will dial the FXO Outbound ZAP trunk after waiting/delay 4 seconds. When I am using softphone elastix will dial immediately the pstn trunk without waiting a second.

    How to make elastix dial immediately pstn trunk without delaying when we are using FXS extension?

    Awaiting your respond soon and thank you very much.

    Best regards,
    Ismed
     
  2. maxmv

    Joined:
    Feb 15, 2010
    Messages:
    4
    Likes Received:
    0
    hi
    i have the same card
    whit 2 fxo and 2 fxs
    can you telme step by step
    how i config for
    incoming calls and out calls
    i cant make to work pleas :(
    new in this elastix

    tnx from advance
     
  3. Patrick_elx

    Joined:
    Dec 14, 2008
    Messages:
    1,120
    Likes Received:
    0
    maxmv, please start a new thread when asking new questions.

    Also please read Elastix Without Tears that is available in the downloads section that will give you a step by step instructions for a few standard setups.

    http://www.elastix.org/content/view/137/60/lang,en/
     
  4. fasilkaks

    Joined:
    Feb 6, 2010
    Messages:
    36
    Likes Received:
    0
    try giving immediate=yes in chan_dahdi.conf
     

Share This Page