Yealink SIP-T22P, phone book & sample .cfg

Discussion in 'IP Phones' started by vbhoj74, Feb 28, 2010.

  1. vbhoj74

    Joined:
    Dec 11, 2009
    Messages:
    11
    Likes Received:
    0
    I'm using a yealink SIP-T22P and trying to auto provision the same with Elastix.

    I used the help from http://www.voip-info.org/wiki/view/SIP-T28 to do auto provisioning, but since the models are different few variables seems to have mismatch. I also wanna know which variables to use in the <mac>.cfg file so that I can provision multiple SIP accounts (the example shows only one) on the phone.

    Since these phones support remote XML phone books, I wonder if I can use the asterisk phone book ? I tried surfing a lot on this topic but do not seem to be heading anywhere, any direction will be much appreciated.

    -thanks.
     
  2. vbhoj74

    Joined:
    Dec 11, 2009
    Messages:
    11
    Likes Received:
    0
    Was able to figure out auto provisioning of multiple SIP accounts, just need to change the path information as mentioned below:

    path=/yealink/config/voip/sipAccount0.cfg
    .
    .
    path=/yealink/config/voip/sipAccount1.cfg
    .
    .
    path=/yealink/config/voip/sipAccount2.cfg
    .
    .
     
  3. rafael

    Joined:
    May 14, 2007
    Messages:
    1,454
    Likes Received:
    1
    Thanks :). You may want to became a beta tester for elastix and help us test Yealink support in future releases.

    Regards,

    Rafael
     
  4. vbhoj74

    Joined:
    Dec 11, 2009
    Messages:
    11
    Likes Received:
    0
    Sure I would love to do that, but i'm no pro, only probably 2-3 mths old to all of this. :(

    Should have started early ! :evil:
     

Share This Page