Upgrading Processor

Discussion in 'General' started by rollinsolo, Aug 4, 2010.

  1. rollinsolo

    Joined:
    Feb 11, 2009
    Messages:
    279
    Likes Received:
    0
    I had a customer with issues when call recording, calls would randomly drop and just act buggy all together until I would turn call recording off, the CPU load was relatively low but I decided to try a faster CPU and see how it goes, today I switched out a p4 2.8 ghz for a p4 3.2 and I am using Elastix 1.6 32 bit. Well it booted right up but from the System Tab in Elastix It shows I am using a P4 2.66 Ghz Processor and when I run cat /proc/cpuinfo it shows the same 2.66Ghz but cpu MHz it shows 1607.811 which is much lower. Is there any thoughts as to what I need to do to make sure the full potential of the upgrade is noticed?
     

Share This Page