Upgrade corrupts Zap channels

Discussion in 'General' started by grpprod, Oct 7, 2008.

  1. grpprod

    Joined:
    Dec 11, 2007
    Messages:
    21
    Likes Received:
    0
    I just upgraded Elastix, FreePBX and CentOS (yum update). The result is that I now cannot make calls using Zap interface. I always get a 'all circuits are busy' response. I reconfigured hardware (TDM400P) using web interface, and also used zapata.conf.rpmsave. No luck.

    I would appreciate some help. Thanks
     
  2. rafael

    Joined:
    May 14, 2007
    Messages:
    1,454
    Likes Received:
    1
  3. grpprod

    Joined:
    Dec 11, 2007
    Messages:
    21
    Likes Received:
    0
    Unfortunately, it does not seem to solve the problem. Tried every copy of zapata.conf I could find, with no luck (.rpmnew, .rpmsave etc.).
    I also notice that automatic detection via the web interface will not work unless I check "There is Sangoma card". As I mentioned, mine is a TDM400P with 4 FXOs.
     
  4. DaveD

    Joined:
    Nov 12, 2007
    Messages:
    597
    Likes Received:
    0
    I have the same card and re-naming the zapata file fixed mine.I didn't need to run hardware detection again just refreshed
     

Share This Page