Unknown caller through DAHDI interface

Discussion in 'General' started by arnas, Nov 21, 2010.

  1. arnas

    Joined:
    Nov 21, 2010
    Messages:
    2
    Likes Received:
    0
    Hello,

    I'm using FXS/FXO board which I bought from http://www.chinaroby.com/ with latest Elastix version.
    The card is http://www.chinaroby.com/english/TDM800 ... k-card.htm.
    Elastix recognizes it in "Hardware Detector" like ATCOM -1600P/16 "ATCOM AX1600P Board.

    With outgoing call's everything is OK, but when I make incoming call, Linksys SPA941 (or other hardphone or softphone) show's me "Unknown".

    How I can solve this problem?
     
  2. arnas

    Joined:
    Nov 21, 2010
    Messages:
    2
    Likes Received:
    0
    Maybe anyone can help me?
     
  3. Lee Sharp

    Joined:
    Sep 28, 2010
    Messages:
    332
    Likes Received:
    0
    From the console (or an ssh shell) type "asterisk -r" and then make an inbound call.

    You are looking for a line like this;

    Code:
    -- Executing [s@ext-did:3] ExecIf("DAHDI/1-1", "1 ?Set(CALLERID(name)=)") in new stack
    As opposed to this;

    Code:
    -- Executing [16091234567@from-trunk:3] ExecIf("SIP/216.123.123.123-00003471", "0 ?Set(CALLERID(name)=8321234567)") in new stack
    From this I can tell that my SIP lines pass caller ID, but my T1 does not. It is on order.

    And the phone numbers and IP addresses are not real. :)
     

Share This Page