Trying to set Elastix channel bank PRI to T1

Discussion in 'General' started by salazarw, Feb 25, 2010.

  1. salazarw

    Joined:
    Sep 3, 2009
    Messages:
    14
    Likes Received:
    0
  2. ramoncio

    Joined:
    May 12, 2010
    Messages:
    1,663
    Likes Received:
    0
    Hi salazarw,
    I think this question is more appropiate for Xorcom support, or maybe you will have it in the Astribank manual.

    Maybe you have to change some jumper inside the unit, that is what I thought.
     
  3. salazarw

    Joined:
    Sep 3, 2009
    Messages:
    14
    Likes Received:
    0
    The solution to the problem turned out to be very simple.

    To those people using an Elastix or any other Xorcom channel bank DO NOT look for a switch on the hardware to change from E1 to T1. This is all done through software.
    If you run into the same problem I had where the xpp.conf file was or if you just want to know how to make the change.

    Solution:

    All I had to do is create an xpp.conf file with one line
     

Share This Page