Time Problems

Discussion in 'General' started by bithead2, Dec 11, 2009.

  1. bithead2

    Joined:
    Sep 12, 2007
    Messages:
    8
    Likes Received:
    0
    The time/date listed in Elastix is correct. The correct time is also displayed when using the 'date' command from the cmd line. When I go to Reports --> CDR Reports, the time stamps on all calls are fast by about 10 hours.

    This is causing major trouble when trying to get the time conditions working properly. Is there another place where the time and or timezone may need to be adjusted?

    Thanks
     
  2. dicko

    Joined:
    Oct 24, 2008
    Messages:
    4,099
    Likes Received:
    0
    Your hardware clock needs to use UTC you then set the offset (TimeZone)


    cat /etc/sysconfig/clock
    will show you what TimeZone you are using,


    date "+%Z%z %H:%M"
    will show the localtime as interpreted.


    how to change stuff is referenced at:

    http://www.linuxselfhelp.com/quick/clock.html
     

Share This Page