T1 and analog card installation

Discussion in 'General' started by fashab123, Dec 25, 2009.

  1. fashab123

    Joined:
    Dec 25, 2009
    Messages:
    4
    Likes Received:
    0
    Hi guys

    is it possible to install 16 port analog card and T1 card together on same elastix server
    i need to install a AX-1600p analog card and rhino R4T1 T1/E1 card on the elastix server by doing this would there be any conflict

    secondly what i need to know is after installing 8 port card do i need to change the context from pstn to zaptel on the new elastix 1.6 version or should i keep it as default from-pstn

    any one pls guide me

    R
    faisal
     
  2. danardf

    Joined:
    Dec 3, 2007
    Messages:
    8,069
    Likes Received:
    12
    Theoretically, yes, but you must know that your CPU (Motherboard), must support several interruptions (1000 IRQ/s) for each card (so 2000 IRQ/s)

    It's enormous.
    If your motherboard is ready to accepte this bandwidth's for the interruptions, ok.
    And I don't talk the setup IRQ's problem. :lol:

    Other problem. One day, you can have a break port into a card. So you must stop completely your server.

    Really, if you are the choice, take a gateway.

    Hmmm, for me, you can use from-pstn by default.... :huh:

    Regards
     
  3. mahpayma

    Joined:
    Sep 24, 2010
    Messages:
    27
    Likes Received:
    0
    Hi,

    what do you mean take the gateway, can you explain about the gateway a little bit.
    sorry I am a new bie
     

Share This Page