Support for SNom 870 and m9 phones

Discussion in 'General' started by van Deventer, Jan 5, 2011.

  1. van Deventer

    Joined:
    Jan 5, 2011
    Messages:
    2
    Likes Received:
    0
    Hi guys

    Can you please tell me if Elastix(2.0.0) support the Snom 870 and m9 phones.
    I would also like to know how to install the Farsouth Comma iAT in elastix.

    Thanx
     
  2. fmvillares

    Joined:
    Sep 8, 2007
    Messages:
    1,785
    Likes Received:
    0
    elastix has support for all sip phones that works with asterisk specially the good ones like snom and the m9 dect solution...then you need to configure them to work correctly...
     
  3. van Deventer

    Joined:
    Jan 5, 2011
    Messages:
    2
    Likes Received:
    0
    Can you maybe direct me to a site where it tells me how to configure my SNom 870 an m9 for elastix. I have Elastix running on a virtual machine and the extension is set up for the 2 phone, but the phone is unable to register to the elastix pabx. I also see that i'm unable to select 870 phone type and M9 phone type in Elastix. It only give me 300, 320 and 360 phone types.

    Thanx
     
  4. fmvillares

    Joined:
    Sep 8, 2007
    Messages:
    1,785
    Likes Received:
    0
    the endpoint configurator is for certain types and is not maintained almost in elastix....the best endpoint module as of today is the freepbx based colsolgrp maintained project and does not support none of the top of the line models that you have...the only way is to make them work manually
     

Share This Page