Sangoma cards

Discussion in 'General' started by miketi, Feb 4, 2009.

  1. miketi

    Joined:
    Feb 4, 2009
    Messages:
    4
    Likes Received:
    0
    I have a Sangoma A101D and an A200 installed. The Elastix hardware detector found them but I can't figure out how to program them into use via the GUI. Is this possible?
     
  2. donhwyo

    Joined:
    Aug 8, 2008
    Messages:
    293
    Likes Received:
    0
    I assume you are running 1.3 stable version. I think you need to run setup-sangoma from the linux command line. It will run a script and set it up for you. Then you need to set up trunks etc.

    If you are running beta up to the first 1.5 it is not working for the a200 for sure dought if the a101 works either but don't now for sure. I thinks there is a new beta i haven't tried yet so can't say about that.

    Don
     
  3. miketi

    Joined:
    Feb 4, 2009
    Messages:
    4
    Likes Received:
    0
    Thanks! that worked. However now I have a bigger problem. I somehow set my admin password into Elastix as a user. I was trying to setup a login for user 101 and instead set the admin login up as a user. Is there a backdoor that would allow me to login as an administrator again?
    Thanks
    -Mike
     

Share This Page