Pulse Dialing and MOH

Discussion in 'General' started by CarlZA, Jun 5, 2010.

  1. CarlZA

    Joined:
    Jun 5, 2010
    Messages:
    2
    Likes Received:
    0
    Hi Guys,

    I'll try to keep this short but detailed. I have an Elastix pbx running Asterisk 1.4.26.1. I have two unique problems which I did not have with my trixbox. The IVR loops when a pulse dial user phones in as it's not receiving the required tones, I have set pulsedial=yes in my chan_dahdi.conf file. Does the placement matter?

    chan_dahdi.conf below:

    ; Auto-generated by /usr/sbin/hardware_detector
    [trunkgroups]

    [channels]
    context=from-pstn
    signalling=fxs_ks
    rxwink=300 ; Atlas seems to use long (250ms) winks
    usecallerid=yes
    hidecallerid=no
    callwaiting=yes
    usecallingpres=yes
    callwaitingcallerid=yes
    threewaycalling=yes
    transfer=yes
    canpark=yes
    cancallforward=yes
    callreturn=yes
    echocancel=yes
    echocancelwhenbridged=no
    faxdetect=incoming
    echotraining=800
    rxgain=0.0
    txgain=0.0
    callgroup=1
    pickupgroup=1
    pulsedial=yes
    ;Uncomment these lines if you have problems with the disconection of your analog lines
    busydetect=yes
    busycount=3


    immediate=no

    #include dahdi-channels.conf
    #include chan_dahdi_additional.conf

    Second issue no matter what I do I cannot get MOH to play, it's just dead silent even with either GUI convert or manual convert and up SCP. The three default ones do play. Very weird.

    My board is a Yeastar TDM-800 "; Span 1: WCTDM/8 "YSTDM8xx REV E Board 9" (MASTER)" with 8 fxs modules.

    Module Example:
    ;;; line="1 WCTDM/8/0 FXSKS"
    signalling=fxs_ks
    callerid=asreceived
    group=0
    context=from-pstn
    channel => 1
    callerid=
    group=
    context=default

    Any suggestions or ideas will be greatly appreciated.

    Regards
    Carl
     
  2. CarlZA

    Joined:
    Jun 5, 2010
    Messages:
    2
    Likes Received:
    0
    Bump, please help.
     
  3. dicko

    Joined:
    Oct 24, 2008
    Messages:
    4,099
    Likes Received:
    0
    I'm confused, How does a "pulse dial" phone produce DTMF, which is necessary to navigate IVR's?

    MOH files are best 16 bit 8k sample mono .wav files, and owned by asterisk, there are dozens of examples out there start with

    http://www.voip-info.org/wiki/view/Usin ... Hold+files
     

Share This Page