problems configuring zap/dahdi trunks

[fervio]

Hello,
I configurate 3 trunks zap/dahdi in my elastix 1.5.2 with 2 port fxo each. Pstn lines for first group, Centrex lines and Cellular interface for second and third group.

In trunk menu i config g0 , g1 and g2.
In outbound routes i config three routes with dial patterns 9|. , 0|. and 5|. and trunks g0 , g1 and g2 respectively.

My problem is that I can only make calls by g0. The other routes are "all lines busy..." message.

To verify a problem exchanged the groups and again, only make call by the route of the trunk g0.

Help please!

 

[DaveD]

In trunk menu i config g0 , g1 and g2.
In outbound routes i config three routes with dial patterns 9|. , 0|. and 5|. and trunks g0 , g1 and g2 respectively.

My problem is that I can only make calls by g0. The other routes are "all lines busy..." message.

To verify a problem exchanged the groups and again, only make call by the route of the trunk g0.

Refer to this post it might help
http://www.elastix.org/index.php?option ... 5&id=21934

Also trunks on dahdi will no longer be gO and so on, it will be 1,2,3 and so on when you set the channels