Problem with sangoma a200 remora

Joined
Feb 1, 2012
Messages
4
Points
0
Hi. I've configured a sangoma a200 with a remora in elastix. I've run detect hardware and done the respective configurations with wancfg_dahdi:

Will this AFT-A200 synchronize with an existing Sangoma T1/E1 card?

WARNING: for hardware and firmware requirements, check:
http://wiki.sangoma.com/t1e1analogfaxing
1. NO
2. YES
[1-2]:1

Would you like to enable hardware DTMF detection?
1. YES
2. NO
[1-2, ENTER='YES']:1

Would you like to enable hardware fax detection?
1. YES
2. NO
[1-2, ENTER='NO']:2

Which codec will be used?
1. MULAW - North America
2. ALAW - Europe
[1-2]:1

Which Operation Mode will be used?
1. FCC
2. TBR21
3. AUSTRALIA
[1-3, ENTER='FCC']:2

but in Elastix web interface there are some channels in the remora (3 out of 4) that appear connected (green) when in fact there aren't any connections to them. I've interchanged the two fxo-2 cards of the remora and the ports with error are also interchanged. I don't know if this shows that the problem is with the fxo-2 cards (they're practically new) or if there's something wrong with the connections or de driver configutaions. thank you
 
Joined
Feb 13, 2008
Messages
99
Points
6
what is the result of the command: dahdi show channels? the system should show what you config from script.
 

Members online

No members online now.

Latest posts

Forum statistics

Threads
30,993
Messages
131,109
Members
17,716
Latest member
Orbit114
Top