Problem with ATCOM-1600P

Discussion in 'Gateways' started by alfalfa82, Feb 18, 2010.

  1. alfalfa82

    Joined:
    Aug 20, 2009
    Messages:
    19
    Likes Received:
    0
    Hi,

    I have this card: ATCOM-1600P, i did a fresh install of the newest elastix, did dahdi_genconf, and when i do lsdahdi i see:
    ### Span 1: ATCOM-1600P/16 "ATCOM AX1600P Board 17"
    17 FXO FXSKS (In use) (SWEC: OSLEC)
    18 FXO FXSKS (In use) (SWEC: OSLEC)
    19 FXO FXSKS (In use) (SWEC: OSLEC)
    20 FXO FXSKS (In use) (SWEC: OSLEC)
    21 FXO FXSKS (In use) (SWEC: OSLEC)
    22 FXO FXSKS (In use) (SWEC: OSLEC)
    23 FXO FXSKS (In use) (SWEC: OSLEC)
    24 FXO FXSKS (In use) (SWEC: OSLEC)
    25 FXO FXSKS (In use) (SWEC: OSLEC)
    26 FXO FXSKS (In use) (SWEC: OSLEC)
    27 FXO FXSKS (In use) (SWEC: OSLEC)
    28 FXO FXSKS (In use) (SWEC: OSLEC)
    29 FXO FXSKS (In use) (SWEC: OSLEC)
    30 FXO FXSKS (In use) (SWEC: OSLEC)
    31 FXO FXSKS (In use) (SWEC: OSLEC)
    32 FXO FXSKS (In use) (SWEC: OSLEC)

    the problem is that the card think that there is lines actually connected, but i have nothing connected to it, it given me a false alarm that some thing is connected so if i try to connect one phone line, and i use a dial plan using group r0 it tries to dial using the first port and its working, second port and the third port and so on with failed, until it reach the first one and then its working,, how do i tell the card that nothing is connected to it?

    Thank you
    Alon
     

Share This Page