Problem in sangoma A200

Discussion in 'Gateways' started by mogaeng, May 13, 2010.

  1. mogaeng

    Joined:
    Oct 8, 2008
    Messages:
    18
    Likes Received:
    0
    dear all
    i have new card sangoma A200 and when i install in elastix 1.6 not work and not see in Hardware Detection
    Please help me
     
  2. Mu_Nizar

    Joined:
    Oct 19, 2010
    Messages:
    5
    Likes Received:
    0
    hi,
    I faced the same problem
    I installed Elastix1.6 and I have a Sangoma A200 card with 4 FXO ports
    Elastix didn't find the card (System --> Hardware Detection --> Detect Sangoma hardware )
    I cannot execute the command"sangoma-setup", when I tried that the result was:-bash: sangoma-setup: command not found
    also I try to find all commands start with"sangoma" I found:
    [root@elastix ~]# sangoma_
    sangoma_brid sangoma_mgd

    note: when the system start booting, I have the following message
    (( ERROR wanpipe configuration file cannot be found
    /etc/wanpipe/wanpipe1.conf))
    can any one help me please
    THANKS
     
  3. Mu_Nizar

    Joined:
    Oct 19, 2010
    Messages:
    5
    Likes Received:
    0
    hi people
    would you give me any help :)
     
  4. cornbread7733

    Joined:
    Oct 23, 2010
    Messages:
    4
    Likes Received:
    0
    I recently had the same issue with 2 - Sangoma B600 cards

    1. From root, try: wancfg_dahdi
    2. Complete the config
    3. Detect Sangoma hardware again.

    Hope this helps,

    matt
     

Share This Page