Probelam con FAX(T.30 T1 TIME OUT)

Discussion in 'Elastix 2.x' started by sebas, Jan 5, 2008.

  1. sebas

    Joined:
    Dec 18, 2007
    Messages:
    6
    Likes Received:
    0
    Hola, tengo problemas para el envio de fax, si llamo a un numero normal , que no es un fax, solo para escuchar el sonido del fax del elastix lo que escucho es un beep aislado cada unos 5 segundos o menos pero no el clasico ruido del fax, dejo el log que me llega por mail

    Your job to 7950775583 failed because:

    No answer (T.30 T1 timeout); too many attempts to send


    ---- Transcript of session follows ----

    Jan 04 16:51:47.32: [ 8856]: SESSION BEGIN 000000056 593047950775583
    Jan 04 16:51:47.32: [ 8856]: HylaFAX (tm) Version 4.3.3
    Jan 04 16:51:47.32: [ 8856]: SEND FAX: JOB 9 DEST 7950775583 COMMID 000000056 DEVICE '/dev/ttyIAX1' FROM '201 <sebastian.colussi@data-express.com.ar>' USER 201
    Jan 04 16:51:47.32: [ 8856]: STATE CHANGE: RUNNING -> SENDING
    Jan 04 16:51:47.32: [ 8856]: <-- [12:AT+FCLASS=1\r]
    Jan 04 16:51:47.32: [ 8856]: --> [2]
    Jan 04 16:51:47.32: [ 8856]: MODEM set XON/XOFF/FLUSH: input ignored, output disabled
    Jan 04 16:51:47.32: [ 8856]: DIAL 7950775583
    Jan 04 16:51:47.32: [ 8856]: <-- [15:ATDT7950775583\r]
    Jan 04 16:52:06.47: [ 8856]: --> [7]
    Jan 04 16:52:16.47: [ 8856]: MODEM TIMEOUT: receiving HDLC frame data
    Jan 04 16:52:16.49: [ 8856]: --> [2]
    Jan 04 16:52:16.49: [ 8856]: DELAY 200 ms
    Jan 04 16:52:16.69: [ 8856]: <-- [9:AT+FRH=3\r]
    Jan 04 16:52:23.69: [ 8856]: --> [0:]
    Jan 04 16:52:23.69: [ 8856]: MODEM <Empty line>
    Jan 04 16:52:23.69: [ 8856]: MODEM TIMEOUT: waiting for v.21 carrier
    Jan 04 16:52:23.69: [ 8856]: --> [2]
    Jan 04 16:52:23.69: [ 8856]: DELAY 200 ms
    Jan 04 16:52:23.89: [ 8856]: <-- [9:AT+FRH=3\r]
    Jan 04 16:52:30.89: [ 8856]: --> [0:]
    Jan 04 16:52:30.89: [ 8856]: MODEM <Empty line>
    Jan 04 16:52:30.89: [ 8856]: MODEM TIMEOUT: waiting for v.21 carrier
    Jan 04 16:52:30.89: [ 8856]: --> [2]
    Jan 04 16:52:30.89: [ 8856]: DELAY 200 ms
    Jan 04 16:52:31.09: [ 8856]: <-- [9:AT+FRH=3\r]
    Jan 04 16:52:38.10: [ 8856]: --> [0:]
    Jan 04 16:52:38.10: [ 8856]: MODEM <Empty line>
    Jan 04 16:52:38.10: [ 8856]: MODEM TIMEOUT: waiting for v.21 carrier
    Jan 04 16:52:38.10: [ 8856]: --> [2]
    Jan 04 16:52:38.10: [ 8856]: DELAY 200 ms
    Jan 04 16:52:38.30: [ 8856]: <-- [9:AT+FRH=3\r]
    Jan 04 16:52:45.30: [ 8856]: --> [0:]
    Jan 04 16:52:45.30: [ 8856]: MODEM <Empty line>
    Jan 04 16:52:45.30: [ 8856]: MODEM TIMEOUT: waiting for v.21 carrier
    Jan 04 16:52:45.30: [ 8856]: --> [2]
    Jan 04 16:52:45.30: [ 8856]: DELAY 200 ms
    Jan 04 16:52:45.50: [ 8856]: <-- [9:AT+FRH=3\r]
    Jan 04 16:52:47.46: [ 8856]: --> [10:NO CARRIER]
    Jan 04 16:52:47.46: [ 8856]: MODEM No carrier
    Jan 04 16:52:47.46: [ 8856]: DELAY 200 ms
    Jan 04 16:52:47.66: [ 8856]: No answer (T.30 T1 timeout)
    Jan 04 16:52:47.66: [ 8856]: SEND FAILED: JOB 9 DEST 7950775583 ERR No answer (T.30 T1 timeout)
    Jan 04 16:52:47.66: [ 8856]: <-- [9:AT+FTH=3\r]
    Jan 04 16:52:47.66: [ 8856]: --> [5]
    Jan 04 16:52:47.66: [ 8856]: MODEM input buffering enabled
    Jan 04 16:52:47.66: [ 8856]: SEND FAILED: JOB 9 DEST 7950775583 ERR No answer (T.30 T1 timeout); too many attempts to send
    Jan 04 16:52:47.66: [ 8856]: <-- [5:ATH0\r]
    Jan 04 16:52:47.76: [ 8856]: --> [2]
    Jan 04 16:52:47.76: [ 8856]: MODEM set DTR OFF
    Jan 04 16:52:47.76: [ 8856]: MODEM set baud rate: 0 baud (flow control unchanged)
    Jan 04 16:52:47.76: [ 8856]: STATE CHANGE: SENDING -> MODEMWAIT (timeout 5)
    Jan 04 16:52:47.76: [ 8856]: SESSION END

    ------- Unsent job status -------
    Destination: 7950775583
    JobID: 9
    GroupID: 9
    Sender: 201
    Mailaddr: xxxxxxxxxxxxxxxxxxx
    CommID: 000000056
    Modem: any
    Submitted From: 192.168.3.70
    Page Width: 209 (mm)
    Page Length: 296 (mm)
    Resolution: 196 (lpi)
    Status: No answer (T.30 T1 timeout); too many attempts to send
    Dialogs: 3
    Dials: 0
    Calls: 3
    Pages: 0
    TotPages: 1
    Attempts: 0
    Dirnum:
     
  2. sebas

    Joined:
    Dec 18, 2007
    Messages:
    6
    Likes Received:
    0
    mi configuracion es elastix----> asterisk---->pstn
     

Share This Page