OpenVox D210P For Proliant ML330

Discussion in 'Gateways' started by ismed, Jan 13, 2010.

  1. ismed

    Joined:
    Oct 1, 2009
    Messages:
    120
    Likes Received:
    0
    Dear Expert,
    Is it possible to use OpenVox D210P E1 card with HP server Proliant ML330 or G3?
    Because I saw that the PCI slot is longer than the D210P PCI card pin.

    Awaiting your respond soon and thank you.

    Best regards,
    Ismed
     
  2. james.zhu

    Joined:
    Feb 13, 2008
    Messages:
    99
    Likes Received:
    0
  3. ismed

    Joined:
    Oct 1, 2009
    Messages:
    120
    Likes Received:
    0
    thanks james,
    i have not tried to install the elastix on this HP G3 (Proliant ML330), I am still trying to know if the card fit to the PCI slot and match to the voltage.

    Please check the attached image, and could you please confirm if the card can be installed in this PCI slot? [​IMG]
     
  4. ismed

    Joined:
    Oct 1, 2009
    Messages:
    120
    Likes Received:
    0
    and belows is the picture when the card already inserted in the pci slot. [​IMG]
     
  5. ismed

    Joined:
    Oct 1, 2009
    Messages:
    120
    Likes Received:
    0
    Will it work with elastix 1.6 (32bit) ?
     
  6. james.zhu

    Joined:
    Feb 13, 2008
    Messages:
    99
    Likes Received:
    0
    hello:
    from the http://h20000.www2.hp.com/bizsupport/Te ... peId=15351, there are 6 slots over the board:
    Expansion Slots All models 6 - Total PCI I/O slots consisting of:

    *
    2 - 64 bit, 33 MHz PCI slots.
    *
    4 - 32 bit, 33 MHz PCI slots.
    ==========================
    i do not which mode you bought, but it should work with 64-bit. commonly, the 64-bit slot support 3.3V. you can install 32-bit elastix.
     

Share This Page