OpenVox B200P problem

Discussion in 'General' started by uomogamma, Feb 18, 2008.

  1. uomogamma

    Joined:
    Feb 17, 2008
    Messages:
    2
    Likes Received:
    0
    Hello,

    I'm new to Elastix. I've installed 0.92.4 version on a PC with a Openvox b200p (working with another PBX software).

    After reboot I've checked on the Port Details if everything is ok, but no cards are present. If I try to detect new hardware nothing happens (No cards were detected on your system. Please press the "Detect New Hardware" button to detect new hardware.)

    I've made something wrong?

    Is it something to manually config to use OpenVox B200 P?

    On the docs on the site B200P is fully supported.

    Can you help me?

    Thank you so much.

    Andrea
     
  2. OpenVox

    Joined:
    Oct 22, 2007
    Messages:
    39
    Likes Received:
    0
    yes. it works perfectly with elastix. B200P uses ?????
     
  3. uomogamma

    Joined:
    Feb 17, 2008
    Messages:
    2
    Likes Received:
    0
    Hello again,

    I've read all the User Manual PDF (english) found on elastix.org site, but mISDN is never mentioned in it. Can you help me? Is there any online docs or howto?

    Thank you
     
  4. OpenVox

    Joined:
    Oct 22, 2007
    Messages:
    39
    Likes Received:
    0
  5. adminad

    Joined:
    Apr 29, 2010
    Messages:
    150
    Likes Received:
    0
    Elastix comes with mISDN pre-installed.

    You just have to detect your card with the command:

    mISDN scan

    Configure your card with the command:

    mISDN config


    and finally start the mISDN service with the command:

    mISDN start

    Please read this document for mor detailed info http://www.misdn.org/index.php/Configuring_mISDN
     

Share This Page