no incoming and outgoing calls on 4 port card

Discussion in 'General' started by kangodan, Mar 29, 2011.

  1. kangodan

    Joined:
    Mar 24, 2011
    Messages:
    4
    Likes Received:
    0
    I have a server running elastix and for some reason began experiencing problems with one of my line on a 4 port sangoma card i have installed on it. When i perform a "service dahdi status" the results is as follow:

    ### Span 1: WRTDM/0 "wrtdm Board 1" (MASTER)
    1 FXO FXSKS (In use) (SWEC: OSLEC)
    2 FXO FXSKS (In use) (SWEC: OSLEC) (EC: OSLEC)
    3 FXO FXSKS (In use) (SWEC: OSLEC)
    4 FXO FXSKS (In use) (SWEC: OSLEC)
    5 EMPTY

    I realized that there is an additional (EC: OSLEC) to the 2nd line which is the line which has the issue. How do i fix this.

    Thank You
     
  2. fmvillares

    Joined:
    Sep 8, 2007
    Messages:
    1,785
    Likes Received:
    0
    ohhh yes we are magicians...and your config files???? versions??? etc....
    first of all u need to read bob fryers post about how to post its sticky in newbies corner
     
  3. kangodan

    Joined:
    Mar 24, 2011
    Messages:
    4
    Likes Received:
    0
    Thanks i read Bobs post to the newbies, i will be sure to get it correct next time. I am using elastix 1.7.0, which of the config files would you like me to get?
     
  4. dicko

    Joined:
    Oct 24, 2008
    Messages:
    4,099
    Likes Received:
    0
    You don't say what your "problems" are but I suggest that you either have hardware error correction on you Sangome card or not, your post suggests that on that channel and that channel only has both SWEC (software) and EC (hardware), please run the Sangoma setup procedure again, (please don't rely on the Elastix method as it is almost certainly broken still)
     
  5. fmvillares

    Joined:
    Sep 8, 2007
    Messages:
    1,785
    Likes Received:
    0
    Re: Re:no incoming and outgoing calls on 4 port card

    BTW elastix 1.7.0 does never existed!
     
  6. kangodan

    Joined:
    Mar 24, 2011
    Messages:
    4
    Likes Received:
    0
    sorry it elastix 1.6
     
  7. fmvillares

    Joined:
    Sep 8, 2007
    Messages:
    1,785
    Likes Received:
    0
    Re: Re:no incoming and outgoing calls on 4 port card

    my best shot with sangoma is always download dahdi and then wanpipe and recompile by hand all the driver as dicko said elastix wanpipe is broken
     

Share This Page