No GUI

Discussion in 'General' started by micropat, May 21, 2010.

  1. micropat

    Joined:
    Apr 28, 2010
    Messages:
    19
    Likes Received:
    0
    I'm trying out a very cost effective piece of hardware- Opliplex 180- in conjunction with Elastix 2.0. I had to install from a USB to CD-RW. The only issue I see when doing the initial install is that the kickstart doesnt load. However; once it's installed, I can't access the GUI at all. I can manipulate the files over the network (WINSCP) and ping it without any issue. Any help would be appreciated.
     

Share This Page