No dialtone

Discussion in 'General' started by fbarajas, Jun 6, 2009.

  1. fbarajas

    Joined:
    Jun 6, 2009
    Messages:
    15
    Likes Received:
    0
    Hi! Newbie on elastix, but I have used other linux distributions before. I'm also a newbie on VoxIP. I'm installing my first elastix with a TDM400P (ntvox) card. The card has 2 FXS and 1 FX0, and it's recognized as shown:


    pan # 1: WCTDM/4 "Wildcard TDM400P REV I Board 5" (MASTER)

    1 FXO
    In Use

    2 FXS
    In Use

    3 FXS
    In Use

    4
    Unknown

    Using FreePBX under Elastix, I added 2 ZAP extensions (101 and 102) on channels 2 and 3.

    My problem is that I only get dial tone on port 3.

    What am I missing?

    Thanks!
     
  2. davidh

    Joined:
    May 13, 2008
    Messages:
    20
    Likes Received:
    0
    not familiar with this card, but it looks like it uses the zaptel(dahdi drivers)

    add your zaptel.conf, zapata-channels.conf, zapata.conf and zapata_additional.conf, and i will see if i can help.
     
  3. fbarajas

    Joined:
    Jun 6, 2009
    Messages:
    15
    Likes Received:
    0
    Thanks for your reply!

    It was a hardware failure: a bad FXS port on the card. Got the port replaced and it's working now.

    Thanks anyway for your reply and greetings from Mexico City.
     

Share This Page