Manually configure PolyCom's

Discussion in 'IP Phones' started by tbooth, Dec 7, 2010.

  1. tbooth

    Joined:
    Feb 24, 2007
    Messages:
    338
    Likes Received:
    0
    So I have a new customer that requested we install PolyCom IP 560's with their new elastix appliance. It seems to me that if you do the whole provisioning thing its a pain in the butt. Is it ok to manually go into the PolyCom GUI and set them up? I'm used to setting mostly Snom phones that way.
     
  2. dicko

    Joined:
    Oct 24, 2008
    Messages:
    4,099
    Likes Received:
    0
    Of course you can do it manually, however more than two and perhaps

    http://www.freepbx.org/forum/freepbx/us ... or-freepbx

    might help you with line appearances, dialling strings etc. it will essentially get you the newest software an set up a basic working unit that is freepbx aware and a template for that hardware. You can then take it from there.
     
  3. tbooth

    Joined:
    Feb 24, 2007
    Messages:
    338
    Likes Received:
    0
    Thanks Dicko, looks like a really good module.
     

Share This Page