limit outgoing baud rate

Discussion in 'General' started by userfromca, Apr 24, 2009.

  1. userfromca

    Joined:
    Jun 30, 2007
    Messages:
    30
    Likes Received:
    0
    I have been mostly successful sending faxes over SIP but sometimes some faxes fail. I suspect that 14400 baud is not a good idea. Is it possible to force an upper limit say 9600 baud for outgoing faxes on hylafax? Where do I set it?

    Other thought is that if I am getting incoming fax on IAXmodem while I am sending out a fax it might get interrupted. Is there way to route outgoing fax to use certain IAXmodem?
     

Share This Page