isdn in hardware detection?

Discussion in 'General' started by satchid, Nov 17, 2009.

  1. satchid

    Joined:
    Sep 13, 2007
    Messages:
    57
    Likes Received:
    0
    Hi,

    I have an ISDN controller: Cologne Chip Designs GmbH ISDN network Controller [HFC-4S] (rev 01)

    when id do the detect hardware, then the following appears:



    Port 1: TE-mode BRI S/T interface line (for phone lines)
    -> Protocol: DSS1 (Euro ISDN)
    -> Layer 4 protocol 0x04000001 is detected, but not allowed for TE lib.
    -> childcnt: 2
    * Port NOT useable for PBX (maybe there is already a PBX running?)
    --------
    Port 2: TE-mode BRI S/T interface line (for phone lines)
    -> Protocol: DSS1 (Euro ISDN)
    -> Layer 4 protocol 0x04000001 is detected, but not allowed for TE lib.
    -> childcnt: 2
    * Port NOT useable for PBX (maybe there is already a PBX running?)
    --------
    Port 3: TE-mode BRI S/T interface line (for phone lines)
    -> Protocol: DSS1 (Euro ISDN)
    -> Layer 4 protocol 0x04000001 is detected, but not allowed for TE lib.
    -> childcnt: 2
    * Port NOT useable for PBX (maybe there is already a PBX running?)
    --------


    Port 4: TE-mode BRI S/T interface line (for phone lines)
    -> Protocol: DSS1 (Euro ISDN)
    -> Layer 4 protocol 0x04000001 is detected, but not allowed for TE lib.
    -> childcnt: 2
    * Port NOT useable for PBX (maybe there is already a PBX running?)
    --------

    What can I do to fix this/


    Thanks,

    Willy
     

Share This Page