Incoming Call Identification issue

Discussion in 'General' started by newboy, May 28, 2010.

  1. newboy

    Joined:
    Mar 11, 2009
    Messages:
    60
    Likes Received:
    0
    Hello,

    I am using Elastix 1.5.2.2 with FreePBX 2.6.0.2. I have 4 trunks from various different providers.

    The issue i am facing is that when i get an incoming call through any of the trunk on the DID's (traditional numbers) that i have purchased from them, the destination comes up as "s". It does not show me the actual DID number through with the call came. I have tried numbers from Ozetell, Pennytel and some other providers but i get the same result.

    i mean the "Destination" shown in reports (which should be the DID through which the call came). The caller ID for a call comes up fine under source. So it displayes the right number under source in the same report but the "Destination" shows "s".

    Due to the above issue i am unable to land calls to different numbers on different destinations. I can only receive calls to one destination by setting up the incoming route to "Any DID/ Any CID".

    If i delete the "Any DID/ Any CID" route and just leave the route for the actual DID then i get a message that the number you have dialed is not in service".

    <b>Here are my configs:</b>

    <b> Pennytel </b>
    <b> PEER Details: </b>
    disallow=all
    allow=alaw&ulaw&gsm&g729
    canredirect=no
    canreinvite=no
    host=sip.pennytel.com
    insecure=very
    secret=XXXXXXXXXXXX
    type=peer
    username=888XXXXXXX

    <b> User Context </b>
    888XXXXXXX

    <b> User Details </b>
    canreinvite=no
    context=from-trunk
    fromuser=888XXXXXXX
    qualify=no
    secret=XXXXXXXXXX
    type=user
    username=888XXXXXXX

    <b>Registration String:</b>
    888XXXXXXX:XXXXXXXXXXXX@sip.pennytel.com/888XXXXXXX

    <b> Oztell </b>
    <b> PEER Details: </b>
    disallow=all
    allow=ulaw&alaw
    canredirect=no
    dtmfmode=rfc2833
    fromuser=899060xxxxx
    host= sip.syd.net2max.com
    insecure=very
    username=899060XXXXX
    secret=Password
    type=peer

    <b> User Context </b>
    899060XXXXX

    <b> User Details </b>
    canreinvite=no
    context=from-trunk
    fromuser=899060XXXXX
    insecure=very
    qualify=no
    secret=Password
    type=user
    username=899060XXXXX

    <b>Registration String:</b>
    899060XXXXX:password@sip.syd.net2max.com/899060XXXXX


    Can anyone please advise or suggest what can be done to fix the above issue?
     
  2. gquiles

    Joined:
    Jul 15, 2010
    Messages:
    10
    Likes Received:
    0
    did you manage to fix this issue?
    im also looking for a solution.
     

Share This Page