Inbound route for g0?

Discussion in 'General' started by tfunk, Sep 10, 2008.

  1. tfunk

    Joined:
    Jun 22, 2008
    Messages:
    17
    Likes Received:
    0
    This is probably a dumb question...

    I'm used to seeing the option for a zap channel when you setup the inbound routes.

    I'm not seeing it in the new version of Elastix.

    How do I set an inbound route for a zap channel?

    Thanks!

    Tfunk
     
  2. DaveD

    Joined:
    Nov 12, 2007
    Messages:
    597
    Likes Received:
    0
    The latest version routes zap different and is no longer named as g0, it will be just 1 or 2 0r 3 as in channel

    To use the zaptel routing you will need to change context in zapata.conf from " from-pstn " to " from-zaptel "
    When that is done goto freepbx and select Zap Channel DID's
    enter the zap channel that shows in detect hardware, so channel would be 1
    Give it a description
    And put in your zap DID
    save and submit

    Then goto inbound routes and add the description and the same DID and send to where you want

    Hope that is what you were looking for
     
  3. Usuarioforum

    Joined:
    Nov 15, 2007
    Messages:
    93
    Likes Received:
    0
    In last version don't apear DID Zap channels. You must to go to Unembedded freePBX. May be a bug???
     

Share This Page