How to setup Sangoma D600 FXO Card in Elastix

Discussion in 'General' started by jbr444, Sep 15, 2009.

  1. jbr444

    Joined:
    Sep 15, 2009
    Messages:
    1
    Likes Received:
    0
    Im looking to get some information on how to setup a Sangoma D600 FXO card in which Im using 4 pots lines to connect to server.

    Right now I setup all my drivers and im able to make incoming calls, but the problem is that the calls are delayed about 15 seconds until it rings the phones and also im unable to make outgoing calls (when I do its showing that the port is in use but its silent) i dont know how to setup the fxo card in elastix, so that each fxo port is its seperate number or how to configure this correctly.

    Can anyone out there help out a newbie, or can point me in the right direction, I looked all over and cannot find a answer. Thanks
     

Share This Page