Help with unicall 1.3

Discussion in 'General' started by garcia.ronald.d, Mar 12, 2009.

  1. garcia.ronald.d

    Joined:
    Sep 24, 2008
    Messages:
    134
    Likes Received:
    0
    Hello friends,

    I use A102 card sangoma,Elastix 1.3 and unicall

    I do the following:

    1.- Copy the chan_unicall.so without the problem to reload in /usr/src/asterisk/modules
    2.- In modules.conf put load chan_unicall.so and commented the second noload chan_unicall.so
    3.- Ran wancfg_zaptel
    4.- Configure the unicall.conf and zaptel.conf with my parameters, this is perfect because this works great with asterisk pure
    5.- Ran ztcfg
    6.- In CLI ran UC show channels and all the channels apperas Idle
    7.- Connected with the E1 and the led appear red instead green
    8.- Custom Trunks: UNICALL/g1/$OUTNUM$
    9.- Outbound routes with UNICALL/g1/$OUTNUM$

    But I cant make calls to the PSTN,

    Anybody can help me? There is something to do that I havent do

    Thanks
     
  2. rafael

    Joined:
    May 14, 2007
    Messages:
    1,454
    Likes Received:
    1
    Can you test Elastix 1.5 RC2? IT uses openR2 that works better than Unicall
     
  3. garcia.ronald.d

    Joined:
    Sep 24, 2008
    Messages:
    134
    Likes Received:
    0
    Hola Rafael ya logré echar a andar el elastix 1.3 con unicall y funciona bien.

    Pero Elastix 1.5 de verdad funciona correctamente el mfcr2 con openr2, es decir está bien integrado?

    Gracias y saludos
     

Share This Page