Help needed with new setup

Discussion in 'General' started by antrax, Jul 4, 2010.

  1. antrax

    Joined:
    Jul 4, 2010
    Messages:
    1
    Likes Received:
    0
    Hello there,
    I'm a new user to elastix and have a couple of issue setting it up for my office. I'm using the TDM410 2 port FXO connected with local land lines.
    I have installed elastix correctly
    I have read elastix without tears and I have successfully set up the following:
    Hardware detection
    extensions
    Outbound rout
    Inbound routs
    Trunks

    I can send and receive calls but only using one channel/line. I have one local number that is equipped with two lines. Elastix without tears does not explain how to set this up. I hope I have the correct digium card :s

    If one extension is using the first line, how will the second extension get access to the second line?
    Also some help with setting up the inbound routs for both lines would appreciated
     
  2. jgutierrez

    Joined:
    Feb 28, 2008
    Messages:
    5,737
    Likes Received:
    0
    Attach the output for:

    1. lsdahdi
    2. cat /etc/asterisk/dahdi_channels.conf
    3. Paste the configuration for the trunk sequence on your outbound route (web interface)
     

Share This Page