Hardware Detection problem

Discussion in 'General' started by Richi_530, Feb 10, 2011.

  1. Richi_530

    Joined:
    Dec 14, 2010
    Messages:
    13
    Likes Received:
    0
    Hi,

    we have just setup the Elastix and connect a E1 PRI to our Wildcard TE220 (5th Gen) (d161:1220).

    But in the Hardware Detection all the channels looks in red.
    Our operator say that the E1 is up in their side and is a problem of us.

    In the Dashboard we can see the Wildcard TE220 (5th Gen) "Registered".

    We can't know the way to activate it?

    Thanks ;)
     
  2. Richi_530

    Joined:
    Dec 14, 2010
    Messages:
    13
    Likes Received:
    0
    Ok, the problem was that the jumper in the Digium Card was selected at T1 instead E1.

    I'm reporting the solution here to help people with the same problem
     

Share This Page