Grafic interface on elastix

Discussion in 'General' started by signo82, Jan 31, 2008.

  1. signo82

    Joined:
    Jan 30, 2008
    Messages:
    17
    Likes Received:
    0
    Hi,
    I installed last version of elastix and it works very well!
    I'd like to know if I can set it directly by the machine I have installed it and not by my computer in the lan typing http://192.168.eccc
    Is there a way to start grafic mode after normal start of pbx?
    Thank you to all!
     
  2. mandimandi

    Joined:
    Jan 19, 2008
    Messages:
    25
    Likes Received:
    0
    Hi,
    the way for do what you want are already work.
    Enough type 192.168.xxx.xxx (elastix IP machine) and work with graphic interface (user=admin and password=palosanto).
    It's right?
    Bye bye
     
  3. ramoncio

    Joined:
    May 12, 2010
    Messages:
    1,663
    Likes Received:
    0
    You will have to install X.
    I did it on my demo laptop without many problems, but I don't remember the exact packages I installed.

    You should start with something like:
    # yum install gdm system-config-display gnome*
    and then after installation you should do
    # system-config-display
    and then
    # startx

    You can change in /etc/inittab your default runlevel (by default is 3, but you cang change it to 5 for X to run at boot).
    I prefer starting at runlevel 3 and then run startx if I want to go into X mode.
     

Share This Page