Getting started

Discussion in 'General' started by sethm, Sep 7, 2010.

  1. sethm

    Joined:
    Sep 7, 2010
    Messages:
    2
    Likes Received:
    0
    I currently have a VoxIP T1 through Windstream. T1 goes to Cisco IAD 2400 series and splits data and voice channels...
    Currently in place is a 3com NBX 100 w/V3000
    Dell PowerConnect 3448p switch.

    If I put n Elastix system in place, do I only have to connect the onboard NIC to the switch for the data, when using IP phones? ...and a T1 x-over from the Cisco to the Elastix T1 card?

    Input appreciated!
     
  2. andyshawn

    Joined:
    Apr 3, 2009
    Messages:
    113
    Likes Received:
    0
    I never had a setup exactly like yours before, but i did similar splitting up a T1 into both data and voice. Everything should work fine, based on how you describe your setup.
     
  3. sethm

    Joined:
    Sep 7, 2010
    Messages:
    2
    Likes Received:
    0
    Thanks Andy,
    I don't have VLANs for Data and Voice for my current setup but am kind of wondering if I have to do this for an Asterisk setup...
     

Share This Page