g729 pass through not working

Discussion in 'General' started by samsu, Sep 15, 2010.

  1. samsu

    Joined:
    Sep 15, 2010
    Messages:
    1
    Likes Received:
    0
    Hi,
    I am using elastix 2.0 and I have couple of ATA's connected as extension. If I am not wrong I can use g729 when calling between extensions but actual codec used is g711.
    I have g729 as preferred codec in ATA's and canreinvite=yes. When I selectt to use only g729 codec in ATA's then calls don't go through between extension.

    let me know if you can give me some pointers and give me some direction to troubleshoot.

    thanks,
    Sam
     

Share This Page