FXO card after install Shoing FXS

Discussion in 'General' started by elastic, Jan 18, 2008.

  1. elastic

    Joined:
    Jan 18, 2008
    Messages:
    2
    Likes Received:
    0
    Dear All,

    I'm Using Elastic-0.9-alpha with TDM800P 8FX0 after updation & Run Hardware detection configure successfully 8FXO card green enable, but i'm runnig 'ztcfg -vv' show me

    [root@elastix ~]# ztcfg -vv

    Zaptel Version: 1.4.6
    Echo Canceller: OSLEC
    Configuration
    ======================


    Channel map:

    Channel 01: FXS Kewlstart (Default) (Slaves: 01)
    Channel 02: FXS Kewlstart (Default) (Slaves: 02)
    Channel 03: FXS Kewlstart (Default) (Slaves: 03)
    Channel 04: FXS Kewlstart (Default) (Slaves: 04)
    Channel 05: FXS Kewlstart (Default) (Slaves: 05)
    Channel 06: FXS Kewlstart (Default) (Slaves: 06)
    Channel 07: FXS Kewlstart (Default) (Slaves: 07)
    Channel 08: FXS Kewlstart (Default) (Slaves: 08)

    8 channels to configure.

    FXS card no FXO wats happen:silly: , its mean wrong configured or signalling issue etc....?
    sip to sip call running but not come to outside, I want only inbound route

    Regards:
    aa
     
  2. DaveD

    Joined:
    Nov 12, 2007
    Messages:
    597
    Likes Received:
    0
    That is what it is supposed to show is the opposite signalling example fxs would read fxo

    Did you create your inbound routes according to your DID numbers or did you create per zaptel channel
     
  3. elastic

    Joined:
    Jan 18, 2008
    Messages:
    2
    Likes Received:
    0
    OK Thanks,with default 'Trunk ZAP/g0' I have created inbound route 'any DID / any CID'. Then when I call elastix I just hear ringing, it does not transfer to the sip extension.
     
  4. DaveD

    Joined:
    Nov 12, 2007
    Messages:
    597
    Likes Received:
    0
    Ok change your ZAP/g0 to zap/1 and so on and should work

    use your CLI to see if the zap cards are actually detecting incoming will help narrow down any issues
     

Share This Page