FOP not showing trunks

Discussion in 'General' started by jnickel, Oct 20, 2008.

  1. jnickel

    Joined:
    Dec 7, 2007
    Messages:
    15
    Likes Received:
    0
    Hi,

    I will provide the background so you know where I am at:

    I installed a Elastix 1.3 onto a IBM 3550 with a Digium TE121B card. Unfortunately, this card made the machine reboot randomly. I got a replacement from Digium and this card caused reboots less frequently, but still happened.

    I then returned the Digium card and got a Sangoma A101DE card. This card has been working without problems since installation. I can make and receive calls across the T1.

    However, the FOP (Flash Operator Panel) does not show the Sangoma trunk. It is available in the FreePBX (embedded).

    What can I do to get the FOP to show the Sangoma trunk (it is Zap/g0)?

    Jim
     
  2. torontob

    Joined:
    May 18, 2008
    Messages:
    219
    Likes Received:
    0
    Same problem here with a Sangoma A400 card. Shall look into it once I get over the Aastra XML hurdle.
     

Share This Page