first setting Elastix 1.4 with 3 analog lines

Discussion in 'General' started by shlomi, Jan 12, 2009.

  1. shlomi

    Joined:
    Jan 7, 2009
    Messages:
    35
    Likes Received:
    0
    hi ,guys

    i have new installtion elastix 1.4 with openvox 4 line analog with fxo X3

    i setup

    1. trunk Zap
    2.setup inbound route to extantion number 22

    now when the first call comming the ext: 22 answer good
    but when the second call arrive the elastix return to the caller that the line is busy and dissconet him and i have 3 lines

    i want the call will wait in the phone at ext 22 until finish to serv the last calleer then pull the call or the call utotmatice beep at the phone

    please help

    best regards
     
  2. abanuz

    Joined:
    Feb 25, 2008
    Messages:
    20
    Likes Received:
    0
    hi;

    Afterone call established succesfully,second call took everytime busy tone for a while.Because of disconnect problem.In your region,Telecom use signalization for understanding of hangup..so you should re-compile zaptel driver with these signal values...What is your region?


    Thanks
     
  3. dicko

    Joined:
    Oct 24, 2008
    Messages:
    4,099
    Likes Received:
    0
    Set ext. 22 to call waiting enable to get the beep. If it has voicemail it should have gone there.

    Unless the trunks are provisioned to "hunt" (or Rollover) then the telco will return busy, not asterisk, this is expected behavior. Check call progress at the Asterisk CLI to confirm that the second call is being answered at all and if it is, the responses should clue you as to what went wrong.
     
  4. shlomi

    Joined:
    Jan 7, 2009
    Messages:
    35
    Likes Received:
    0
    solved tnx

    i setup ring group and if no answer it is call back to it
    with music on hold


    TNX
     

Share This Page