Fax and multi iaxmodem per one DID

Discussion in 'General' started by kdrewicz, Jun 10, 2008.

  1. kdrewicz

    Jun 10, 2008
    Likes Received:
    found an issue with faxing,

    i whould like to setup a simple fax-to-email gateway.

    my trunk side is a legalcy PABX with E1/PRA (DSS-1) connection. The first problem was to add:
    to my zapata.conf by hand (is there a way to do it in elastix GUI?).

    Second is that i have to declare DID number (an extension), for me it whould be something like 4001 to 4010.

    and if i use 10 extensions with IAX2 type and 10 IAXmodem (virtual fax) it's quite good, but... if i have a "high traffic hours" i whould like to receive as many faxes (like 4-5) to one DID number, and route them to one email (in PDF attachment).

    normaly i whould use a

    exten => 4001,1,Dial(IAX2/ttyIAX0/${EXTEN})
    exten => 4001,2,Dial(IAX2/ttyIAX1/${EXTEN})
    exten => 4001,3,Dial(IAX2/ttyIAX2/${EXTEN})

    and have a IAX0, IAX1 and IAX2 configured to connect to hylafax, then the hylafax will receive the ${EXTEN} info, so the DID number dialled by other party.

    how could I obtain this funcionality in Elastix?

Share This Page