FATAL: Module zaphfc not found

netorange

Joined
Dec 23, 2010
Messages
2
Likes
0
Points
0
#1
Hi all, i've a fresh install of elastix 2
i've two pci isdn card that works well with my previous elastix 1.6 (with misdn) but now i don't be able to get working via dahdi and also via misdn
some reports below:

lspci -v
05:02.0 Network controller: Cologne Chip Designs GmbH ISDN network controller [HFC-PCI] (rev 02)
Subsystem: Cologne Chip Designs GmbH ISDN Board
Flags: bus master, medium devsel, latency 16, IRQ 3
I/O ports at dc70
Memory at fe6bfe00 (32-bit, non-prefetchable)
Capabilities: [40] Power Management version 1

05:04.0 Network controller: Cologne Chip Designs GmbH ISDN network controller [HFC-PCI] (rev 02)
Subsystem: Cologne Chip Designs GmbH ISDN Board
Flags: bus master, medium devsel, latency 16, IRQ 11
I/O ports at dc78
Memory at fe6bff00 (32-bit, non-prefetchable)
Capabilities: [40] Power Management version 1

dahdi_hardware
pci:0000:05:02.0 zaphfc- 1397:2bd0 HFC-S ISDN BRI card
pci:0000:05:04.0 zaphfc- 1397:2bd0 HFC-S ISDN BRI card

dahdi_genconf -v
Default parameters from /etc/dahdi/genconf_parameters
Empty configuration -- no spans
Generating /etc/dahdi/system.conf
Empty configuration -- no spans
Generating /etc/asterisk/dahdi-channels.conf

dahdi_cfg -vvv
DAHDI Tools Version - 2.4.0
Notice: Configuration file is /etc/dahdi/system.conf
line 0: Unable to open master device '/dev/dahdi/ctl'

1 error(s) detected

cat /proc/dahdi/*
cat: /proc/dahdi/*: No such file or directory


/etc/init.d/dahdi start
Loading DAHDI hardware modules:
FATAL: Module dahdi not found.
wct4xxp: FATAL: Module wct4xxp not found. [FALLITO]
opvxd115: FATAL: Module opvxd115 not found. [FALLITO]
wcte12xp: FATAL: Module wcte12xp not found. [FALLITO]
wct1xxp: FATAL: Module wct1xxp not found. [FALLITO]
wcte11xp: FATAL: Module wcte11xp not found. [FALLITO]
wctdm24xxp: FATAL: Module wctdm24xxp not found. [FALLITO]
wcfxo: FATAL: Module wcfxo not found. [FALLITO]
wctdm: FATAL: Module wctdm not found. [FALLITO]
wcb4xxp: FATAL: Module wcb4xxp not found. [FALLITO]
wcb4xxp-extra: FATAL: Module wcb4xxp_extra not found.[FALLITO]
wctc4xxp: FATAL: Module wctc4xxp not found. [FALLITO]
xpp_usb: FATAL: Module xpp_usb not found. [FALLITO]
opvxa1200: FATAL: Module opvxa1200 not found. [FALLITO]
ystdm8xx: FATAL: Module ystdm8xx not found. [FALLITO]
ystdm16xx: FATAL: Module ystdm16xx not found. [FALLITO]
ap400: FATAL: Module ap400 not found. [FALLITO]
dahdi_dynamic_eth: FATAL: Module dahdi_dynamic_eth not found.[FALLITO]
dahdi_dynamic_ethmf: FATAL: Module dahdi_dynamic_ethmf not found.[FALLITO]
ax1600p: FATAL: Module ax1600p not found. [FALLITO]
zaphfc: FATAL: Module zaphfc not found. [FALLITO]
wcopenpci: FATAL: Module wcopenpci not found. [FALLITO]
rxt1: FATAL: Module rxt1 not found. [ OK ]
r1t1: FATAL: Module r1t1 not found. [ OK ]
rcbfx: FATAL: Module rcbfx not found. [ OK ]


trying with mISDN (working with previous elastix version)

/etc/init.d/mISDN scan
2 mISDN compatible device(s) found:
>> hfcpci
>> hfcpci

/etc/init.d/mISDN config
Writing /etc/mISDN.conf for 2 mISDN compatible device(s):
>> hfcpci
>> hfcpci

/etc/init.d/mISDN start
-- Loading mISDN modules --
>> /sbin/modprobe --ignore-install capi
>> /sbin/modprobe --ignore-install mISDN_core debug=0
FATAL: Module mISDN_core not found.
>> /sbin/modprobe --ignore-install mISDN_l1 debug=0
FATAL: Module mISDN_l1 not found.
>> /sbin/modprobe --ignore-install mISDN_l2 debug=0
FATAL: Module mISDN_l2 not found.
>> /sbin/modprobe --ignore-install l3udss1 debug=0
FATAL: Module l3udss1 not found.
>> /sbin/modprobe --ignore-install mISDN_capi
FATAL: Module mISDN_capi not found.
>> /sbin/modprobe --ignore-install hfcpci protocol=0x2,0x2 layermask=0xf,0xf
FATAL: Module hfcpci not found.
>> /sbin/modprobe --ignore-install mISDN_dsp debug=0 options=0
FATAL: Module mISDN_dsp not found.
creating device node: /dev/mISDN

beta repo enable and yum updated
kernel 2.6.18-194.26.1.el5

thanks for some help
regards
Paolo
 

netorange

Joined
Dec 23, 2010
Messages
2
Likes
0
Points
0
#2
Re:FATAL: Module zaphfc not found [SOLVED]

just found an open bug Problem running Dahdi

BUG Solved, was a kernel issue
Paul
 

cooperbr

Joined
Jun 4, 2007
Messages
105
Likes
0
Points
0
#3
hello, what is the procedure to solve this problem.

thanks
 

akldjian

Joined
Jul 26, 2011
Messages
219
Likes
0
Points
0
#4
I'm guessing a kernel update. =0)

Andrey
 

mcordas

Joined
Sep 2, 2011
Messages
20
Likes
0
Points
0
#5
Had the same message... Solved !

Origin : I had the "Centos-Plus" repo activated by mistake. It resulted in the installation of a new kernel from that repo... with no zaphfc module.

Reverting to the kernel from Elastix repo solved the issue after reboot.
 

farshidg

Joined
Feb 5, 2012
Messages
8
Likes
0
Points
0
#6
Did anyone manage to fix this?

i have the same problem i guess. My kernel version is as follows:

kernel-headers Header files for the Linux kernel for use by glibc 2.6.18 194.3.1.el5 elastix-updates Installed
Updated


(from the update list)

Farshid
 

Members online

No members online now.

Latest posts

Forum statistics

Threads
30,900
Messages
130,884
Members
17,561
Latest member
marouen
Top