error message after install

Discussion in 'General' started by darshan, Dec 11, 2009.

  1. darshan

    Joined:
    Dec 11, 2009
    Messages:
    2
    Likes Received:
    0
    After installing elastix.When booting up elastix.I get the following message

    VFS: Cannot open root device "VolGroup00/LogVo100" or unknown-block(0,0)
    Please append a correct "root=) boot option
    Kernel panic - not syncing: Unable to mount root fs on unknown-block(0,0)

    Can you please help me.
     
  2. rafael

    Joined:
    May 14, 2007
    Messages:
    1,454
    Likes Received:
    1
    Maybe grub was not installed? the easiest thing to do is to install it again.

    regards,

    rafael
     
  3. darshan

    Joined:
    Dec 11, 2009
    Messages:
    2
    Likes Received:
    0
    I have downloaded latest elastix 1.6 and seems to have sorted out problem.I am now experiencing a problem with non-sync error and a noise on FXS ports after installing 2 X 16 way cards(FXO and FXS)digium cards. I have installed on 3 different motherboards. Still getting same error.Any suggestions
     
  4. franjillo

    Joined:
    Sep 13, 2010
    Messages:
    1
    Likes Received:
    0
    Try reinstalling version 2.0.2 and i still get the same error, any advice?
     

Share This Page