ELASTIX + PCI-CARD TDM400

Discussion in 'General' started by LedZep, Nov 11, 2010.

  1. LedZep

    Joined:
    Nov 11, 2010
    Messages:
    1
    Likes Received:
    0
    Hi Fellows ...

    I wanna require some of your knowledge on the follwing issue:

    * Any idea how to configure an Asterisk PCI-Card TDM400 on Elastix. I think it's something with UDP ports, but I'm a little bit confused about this.

    My AsteriskPCI have 2FXO ports and 2FXS ports.

    Any suggestions or comments, will be granted.

    Thanks a lot
     
  2. Bob

    Bob

    Joined:
    Nov 4, 2007
    Messages:
    2,400
    Likes Received:
    1
    Ledzep,

    No doubt you have the card installed. As you have FXS ports, you also need the power applied to the TDM400 Card (using a molex power connector).

    One you have done this, reboot, and when booted up, access the Elastix GUI and select SYSTEM on the menu, and then HARDWARE DETECTION. It should automatically detect the card and configure it.

    If it does not do this, then you may have a faulty card.

    If you haven't already, take a look at Elastix Without Tears (google for the link), as this will take you through it, even though some parts need updating.

    And it has nothing to do with UDP.....wrong track...

    Regards
    Bob
     

Share This Page