elastix not releasing inbound pstn call

Discussion in 'General' started by Oosthuizen, Apr 6, 2011.

  1. Oosthuizen

    Joined:
    Jun 22, 2010
    Messages:
    59
    Likes Received:
    0
    hello friends
    i have digium card in my elastix, on inbound calls elastix is picking up the call but if the call is not answered then elastix does not release the line
    i have to disconnect the line from the digium port to get it to work again


    i fixed it about a 3 months ago but cannot remember where, i saw something like this
    "if your pstn line is not being released then activate the following to lines"
    i am also not sured about the exact wording "sorry"

    i have been going through all files related to digium but cannot find it

    please if someone can help

    regards
     
  2. jgutierrez

    Joined:
    Feb 28, 2008
    Messages:
    5,737
    Likes Received:
    0
    You have a hangup detection issue, in order to fix it yan can do any of these two steps:

    1. Busy detect
    Edit /etc/asterisk/chand_dahdi.conf
    Uncomment busydetect=yes
    Uncomment busycount, and set it to 8
    Execute from console asterisk -rx "module reload"

    2. Enable reversal polarity with your analog provider
    Comment busydetect and busycount fields
    Write down:
    hanguponpolarityswitch=yes
    Execute from console asterisk -rx "module reload"

    I will also recommend taht you read "Elastix without tears", it will help you understanding a lot of basic configurations.
     
  3. Oosthuizen

    Joined:
    Jun 22, 2010
    Messages:
    59
    Likes Received:
    0
    you clever man

    that's the file i was looking for

    highly appreciated

    thanks a lot
     

Share This Page