Elastix 2 will not recognise a TP-Link NIC

Discussion in 'IP Phones' started by MGG, Aug 26, 2010.

  1. MGG

    MGG

    Joined:
    Aug 29, 2009
    Messages:
    41
    Likes Received:
    0
    Elastix 2 will not recognise TP-Link TF-3239DL (10/100 PCI NIC) Network interface card.

    I have abrand new machine and have always used these cards and disabled to onboard card.

    Now I am stuck can anyone tell me how to get up and running with a TP-Link TF-3239DL or
    TP-Link TF-TG3269 (Gigabit PCI NIC)

    :(
     
  2. ramoncio

    Joined:
    May 12, 2010
    Messages:
    1,663
    Likes Received:
    0
    Do they work in a clean CentOS installation? If so, please take the time to fulfill a bug report in http://bugs.elastix.org
    But I'm afraid they might not be supported by CentOS. So at the moment, go and buy another compatible pci nic.
     
  3. MGG

    MGG

    Joined:
    Aug 29, 2009
    Messages:
    41
    Likes Received:
    0
    Hi ramoncio

    Thanks you for your reply. I am happy to advise that I ran the full installation again with the NIC installed into the PCI and the install picked up the NIC and asked me all the right questions about its configuration. Very nice ( ellegent)to do that with the new version. However unlike the old version 2.6 it does not allow you to install without the nic and reboot after with the nic and have it recognised on reboot.
     

Share This Page