Elastix 2.0 & Draytech miniVigor 128 ISDN TA

Discussion in 'General' started by boodu, Aug 10, 2010.

  1. boodu

    Joined:
    Aug 10, 2010
    Messages:
    4
    Likes Received:
    0
    Hello,

    I have a litle BRI card Draytech miniVigor 128 ISDN TA. It works with Elastix 1.6 with mISDN. My loaded modules are :
    mISDN_dsp,hfcsusb,mISDN_capi,l3udss1,mISDN_l2,mISDN_l1,mISDN_capi,capi.

    misdnportinfo says :
    Port 1: TE-mode BRI S/T interface line (for phone lines)
    -> Protocol: DSS1 (Euro ISDN)
    -> Layer 4 protocol 0x04000001 is detected, but not allowed for TE lib.
    -> childcnt: 2

    I want to migrate to Elastix 2.0 because I have some troubleshooting. MISDN is not supported by Elastix 2.0. I loose to install my hardware with DAHDI. Nothing is detected by dahdi in the Elastix's gui or with dahdi_scan. Is it possible to work it with DAHDI ? How to do ?

    Thanks,
    boodu.
     

Share This Page