Elastix 1.6 freezes during bootup

Discussion in 'General' started by MST, Mar 29, 2010.

  1. MST

    MST

    Joined:
    Sep 25, 2009
    Messages:
    317
    Likes Received:
    0
    Elastix 1.6 just freezes druing bootup and the last process is APF.

    DELL POWER EDGE 2600 has 3 SCSI + extra SATA 500GB

    First it takes a while to NFS STATD to go through and CEntos stuks on APF. The last process:

    STARTING mDNSRESPONDER OK
    STARTING APF: ip_tables ..........
    Netfiller v 0.3
    ip_contract (ver 2.4 8192 buckets, 65536) 288 bytes per bucket and freez forever

    recently added SATA as LVM extra space but had rebooted 3 times and worked .... just 4th time was not lucky....


    Any advice highly appreciate.

    Thank You
     
  2. dicko

    Joined:
    Oct 24, 2008
    Messages:
    4,099
    Likes Received:
    0
    If you care to install a third-party firewall and it doesn't start and blocks your system,perhaps you should be posting this in that firewall's forum, don't you agree ?

    If you setup an NFS export you need to know how it works, and particularly how it will interact with your firewall.

    Sorry but these are just not Elastix related problems, good luck.

    dicko

    p.s.

    Please don't rely on luck, it just isn't effective in the long run, I recommend understanding as a replacement.
     
  3. MST

    MST

    Joined:
    Sep 25, 2009
    Messages:
    317
    Likes Received:
    0
    finally I could boot up in INTERACTIVE MODE, disabled APF and iptables BUT

    can't get http working, aslo can't get using putty,

    when I restart HTTP I have:

    WARNING TIMER ISR/0 TIME WENT BACKWARDS ........... delta_cpu=lot's of numbers
    cpu_processed=lot's of numbers
    0: lot's of numbers
    1: lot's of numbers


    any advice or I should start resintaling Elastix ... ?


    THX
     
  4. dicko

    Joined:
    Oct 24, 2008
    Messages:
    4,099
    Likes Received:
    0
    Don't boot the xen kernel unless you need it, (it breaks many hardware's, and more than a few low level software's, dev's are you listening ?)

    don't install anything unless you know what you are doing,

    Try and restore within you're skill set,

    but probably in your case, "Start Over" :)

    dicko
     
  5. MST

    MST

    Joined:
    Sep 25, 2009
    Messages:
    317
    Likes Received:
    0
    Re:Elastix 1.6 freezes during bootup - RESOLVED

    Found the problem ..... hardware related. I was blamed poor APF :) ...


    Thank You dicko B)
     

Share This Page