Elastix 1.6 beta - A200 cannot outbound calls

Discussion in 'General' started by pepe666, Oct 31, 2009.

  1. pepe666

    Joined:
    Oct 31, 2009
    Messages:
    9
    Likes Received:
    0
    Hi all,

    I test the new release of Elastix 1.6 Beta, cos to fix some issues of card detection (I use an A200 sangoma with 2 FXO) from previous version.

    The card A200 is not detected if you use the web interface, but if you run the command /usr/sbin/hardware_detector -tv then the card show up :) and wanpipe runs perfectly.

    Also the FOP show up the card channels so also this has been fixed.

    Unfortunately, I was not able to make any outbound call but can receive with no problems.

    When I call outside I got the classic "All Circuits Are Busy Now". I tried to fix this issue for the last couple of days with no success. If anyone feel in good mood today to share some ideas and help me out with this problem, maybe someone that use same card, would be really appreciate.

    Thanx

    Pepe
     
  2. pepe666

    Joined:
    Oct 31, 2009
    Messages:
    9
    Likes Received:
    0
    Forgot to say that also the issue with the Kernel Panic has been fixed.

    Regards

    Maurizio
     
  3. pepe666

    Joined:
    Oct 31, 2009
    Messages:
    9
    Likes Received:
    0
    Hi again,

    I have found the issue with the A200 for calling outside. Practically I have only 1 FXO module (2 ports) and it was connected on port 3 and 4. Then I moved the module from the card on port 1 and 2 and then I was able to call outside.

    Anyone knows why? Is there a technical explanation?

    Regards

    Pepe
     

Share This Page