Elastix 1.5 RC1 64bit

Discussion in 'General' started by mihpel, Mar 5, 2009.

  1. mihpel

    Joined:
    May 8, 2007
    Messages:
    87
    Likes Received:
    0
    While trying to setup elastix 1.5-rc1-64bit i stumbled upon a problem that seemed to be worth mentioning.

    My testbed is an hp proliant ML115 powered by an amd 64bit opteron.

    To get to the point the 64 bit rc1 will not run anaconda and it can not proceed to the actual installation.

    Console reports do not indicate anything other than the usual
    Code:
    WARNING: Graphical installation not available... Starting text mode.
    And after that it just halts . Not freeze, just stays there displaying a blue screen (bad memories) doing nothing more.


    32bit rc1 as well as stable 1.3 sets up fine.


    Just a quick note: at boot the distro loads sata_nv driver (if it matters).

    Does any of the above ring a bell to anyone ?
     
  2. edvarg

    Joined:
    Apr 4, 2009
    Messages:
    4
    Likes Received:
    0
    The same happens to me, Proliant ML150 G5, Array 1 with 2 SATA disks.
    Intel processors.
     

Share This Page