DID's on E1 line to specific Extensions

Discussion in 'General' started by anilram, May 16, 2010.

  1. anilram

    Joined:
    May 16, 2010
    Messages:
    4
    Likes Received:
    0
    Hello, I have a setup with a E1 line and DID numbers, but do not know how to direct calls to specific DID numbers to specific extensions. System is up and running with calls in and out working fine, but cannot understand how to configure DID's to extensions. any help would be much appreciated.
     
  2. anilram

    Joined:
    May 16, 2010
    Messages:
    4
    Likes Received:
    0
    anyone can help ?
    The system is using the latest elastix download, using a single span Digium t1/e1 card, system is up and running on Pri line using a incoming group and all calls go to the incoming group. We have a set of 100 DID's from the telco and need to direct some of the numbers to specific extensions.

    I am a newbie at this and would appreciate some help. I have gone through the documentation/wiki and cannot understand how to acheive this.
     

Share This Page