Diagnostic Checks on FXO/FXS ports

Discussion in 'General' started by jmorrison26, Apr 21, 2010.

  1. jmorrison26

    Joined:
    Mar 5, 2010
    Messages:
    26
    Likes Received:
    0
    Hi Guys,

    I am currently having issues receiving calls on Digium card ports. I am trying to run some checks to confirm if this problem is associated with defective ports on the card.

    Can you advise of any CLI commands that will give information on current state and of FX0/FXS ports.

    Thanks
     
  2. hinzinho

    Joined:
    Sep 18, 2009
    Messages:
    461
    Likes Received:
    0
    CLI> core show channels
     
  3. jmorrison26

    Joined:
    Mar 5, 2010
    Messages:
    26
    Likes Received:
    0
    Are there also any commands to check if its actually the module(s) on the digium card thats defective and not the ports on the card.

    Thanks
     
  4. aerodesliza

    Joined:
    Apr 11, 2010
    Messages:
    206
    Likes Received:
    0
    You can use the web gui interface, just go to Hardware detection
     
  5. ramoncio

    Joined:
    May 12, 2010
    Messages:
    1,663
    Likes Received:
    0
    Hi jmorrison26,

    You'd better have a look here:

    http://www.voip-info.org/wiki/view/DAHDI

    paying special attention to the latest lines, the Tools section.

    Also see with dmesg how your dahdi modules load when dahdi service is restarted.
    Finally configure the Elastix/freepbx part and then you should be able to use all dahdi commands from asterisk console, or see the asterisk full log is chan_dahdi doesn't load.
     

Share This Page