control string

Discussion in 'General' started by velez, Mar 26, 2009.

  1. velez

    Joined:
    Jul 18, 2008
    Messages:
    55
    Likes Received:
    0
    I have a box that has two selenoids and a telephone jack. this box is connected to a ATA box with an extension number.

    If call the extension the box answers and request a password and after you can issue a command which opens door 1 or 2 the complete command is (with password)

    Door 1 111111#*611#
    Door 2 111111#*621#

    I need that feature code that I dial *1 and it would dial 111111#*611#

    Any idea is welcome.
     
  2. rafael

    Joined:
    May 14, 2007
    Messages:
    1,454
    Likes Received:
    1
    Hi sounds nice :)

    About the *1 you might one to create a misc destination that would dial the numaber and a misc application that calls your misc destination.

    Regards,

    RAfael
     
  3. velez

    Joined:
    Jul 18, 2008
    Messages:
    55
    Likes Received:
    0
    the box to open door is connected to a ATA. Extension 103. If I call this extension the box responds. I need to enter the password (111111#) and then the command *611#. I try to do Misc. Destination to dial 111111#*611#. then I did a Misc application to that if I dial **1 to use the Misc Destination. It did not work
     
  4. velez

    Joined:
    Jul 18, 2008
    Messages:
    55
    Likes Received:
    0
    enclose is a diagram
     
  5. velez

    Joined:
    Jul 18, 2008
    Messages:
    55
    Likes Received:
    0
    One more time enclose is the drawing.
     

Share This Page